APWA Character Stand-Ups

Instructions and Downloads

Included below is everything your professional vendor needs to produce the P.W. Paws and Chipper Stand ups.

You should have the stand ups produced on a laminated substrate mounted to 1/2” or thicker Gatorboard (thinner Foamcore board will not be rigid enough for use.) Once mounted, the standups will need to have easels mounted to the back of them, your professional vendor may have to custom make an application to fit each APWA standup.

To create the stand ups, your vendor needs the files provided below.

Paws Standup


Full size: 48”X 72” (NOTE: image shown above is not to scale, included for reference only)
Full color artwork
8.5”X 11” reference page for trimming of the P.W. Paws standup


Chipper Standup



Full size: 36”X 48” (NOTE: image shown above is not to scale, included for reference only)
Full color artwork
NOTE: The Chipper Character Standup does not have a “Cut” file because there is no special trimming that is needed. Simply cut out Chipper along the outlines of the artwork.


Questions?


If you have any questions, concerns, or special requests please contact Dave Dancy by e-mail  or by phone at (816) 472-6100, extension 5250.